Ultrasonic sensor UC2000-L2M-E7-T-2M - фото 1 - id-p95194970

Характеристики и описание

Описание оборудования
Single head system
General specifications
Sensing range	60 ... 2000 mm
Adjustment range	80 ... 2000 mm
Dead band	0 ... 60 mm
Standard target plate	100 mm x 100 mm
Transducer frequency	approx. 175 kHz
Response delay	minimum : 60 ms factory setting: 120 ms
Indicators/operating means
LED green	Operating display
LED yellow 1	switching state switch output 1
LED yellow 2	switching state switch output 2
LED red	error
Electrical specifications
Operating voltage	10 ... 30 V DC , ripple10%_SS
No-load supply current	? 50 mA
Interface
Interface type	Serial interface (programming adapter required) 9600 BPS, no parity, 8 data bits, 1 stop bit
Input/Output
Input/output type	1 synchronization connection, bidirectional
Synchronization frequency
Output
Output type	2 switch outputs NPN, NO/NC, programmable
Rated operating current	200 mA , short-circuit/overload protected
Voltage drop	? 2 V
Repeat accuracy	? 0.1 % of full-scale value
Switching frequency	? 5 Hz
Range hysteresis	programmable , preset to 1 mm
Temperature influence	< 1.5 % of full-scale value
Compliance with standards and directives
Standard conformity
Approvals and certificates
CCC approval	CCC approval / marking not required for products rated ?36 V
Ambient conditions
Ambient temperature	-40 ... 70 °C (-40 ... 158 °F)
Storage temperature	-40 ... 85 °C (-40 ... 185 °F)
Mechanical specifications
Connection type	cable , 5-pin
Degree of protection	IP67
Material
Cable
Mass	345 g
Factory settings
Output 1	near switch point: 80 mm far switch point: 2000 mm output function: Window mode output behavior: NO contact
Output 2	near switch point: 150 mm far switch point: 1000 mm output function: Window mode output behavior: NO contact
Beam width	wide
Evaluation procedure	averaging (MxN) M = 5 N = 2
General information
Supplementary information	Switch settings of the external programming adapter: "output load": pull-up "output logic": inv